You have no items in your shopping cart.
Filters
Search
Close

DTF BLACK Adhesive Powder Ecofreen 1 Lb /500gr

Delivery date: 1-2 days
The Black DTF powder dedicated to giving bit better quality on black garments. This powder can be cured in the oven, with a heat gun or under a heat press. To cure your transfers under a heat press you will need to follow these steps. 1. Place your transfer on top of a heat press pillow or heat press foam. 2. Lower the top heat plate until it’s approximately 1cm away from the transfer. 3. Cure the powder for around 5 minutes at 170 C or until melted.
£16.00 inc VAT
Availability: In stock
Designed for use on Black garments only.
+ -
  1. DTF(Direct To Film) products works with almost all types of fabrics including 100% polyester with good quality results !
  2. Does not require pre-treatment and use minimum 75% less DTG inks on to get good quality .
  3. The Fabrics  designed  good wash characteristics.
  4. The fabric has very slight hand feel touch
  5. The process is much faster than Vinly printing.
  6. You don t need DTF printer or DTF inks ,with Ecofreen use your DTG inks!!!!

1. Print the image onto the matte side of film in mirror mode. (CMYK >> White ink) 

2. Apply Ecofreen hot melt powder evenly and remove the excess powder.

3. Hovering to bake the hot melt powder (170°C, 5min)

4. Transfer the image by heat press at 140°C for 15sec with medium pressure. 

5. Cold peel (remove the film gently)

6. Heat press again for curing (140°C, 5 sec) with medium pressure.

  1. DTF(Direct To Film) products works with almost all types of fabrics including 100% polyester with good quality results !
  2. Does not require pre-treatment and use minimum 75% less DTG inks on to get good quality .
  3. The Fabrics  designed  good wash characteristics.
  4. The fabric has very slight hand feel touch
  5. The process is much faster than Vinly printing.
  6. You don t need DTF printer or DTF inks ,with Ecofreen use your DTG inks!!!!

1. Print the image onto the matte side of film in mirror mode. (CMYK >> White ink) 

2. Apply Ecofreen hot melt powder evenly and remove the excess powder.

3. Hovering to bake the hot melt powder (170°C, 5min)

4. Transfer the image by heat press at 140°C for 15sec with medium pressure. 

5. Cold peel (remove the film gently)

6. Heat press again for curing (140°C, 5 sec) with medium pressure.